Hello

Back then I bought the “WLAN Repeater” AirTies 4920 from Swisscom.

It worked very well until now, but has since been replaced by the new one.

Now I want to put the repeater into AP mode again, but I can’t log into the admin interface.

Lt. Manufacturer this is possible as follows:

IP: 192.168.2.254

Username: admin

Pwd: <blank> or more see here: [https://www.192-168-1-1-ip.co/router/airties/air-4920/1216/](https://www.192-168 -1-1-ip.co/router/airties/air-4920/1216/)

I can get to the login page, but with none of the passwords. What I set back then doesn’t work either.

I have already performed the reset 4 times.

Does anyone else have a tip?

Do I have to connect the device to my WiFi with WPS beforehand and then I can access the device?

Thanks and LG

Also thank you for the information. I was in the Swisscom shop today to ask what audio/video standards the current UHD box can do. Unfortunately no one knew. In any case, my Apple TV 4K can do Dolby Atmos and Dolby Vision. But there aren’t too many films about it. I’m currently in the process of converting everything to 4K, including AV receiver, TV box, TV set, Blu-Ray player.