@Chris99, ​​I followed the instructions for Wingo TV on this page:
[https://www.jaqpot.net/wp/2021/01/29/wingo-draytek-vigor166-pfsense/](https://www.jaqpot.net/wp/2021/01/29/wingo-draytek -vigor166-pfsense/)
It’s about Wingo TV & PFSense, but it works 100% for Swisscom TV and OPNSense

👌Bluto

@Bluto all clear, thanks. I connected the Swisscom TV box directly to the Opnsense router and made the multicast entries on opnsense.

Hi @Bluto - do you think it’d be feasible to stick the SFP module from the Zyxel directly into the OPNsense appliance (mine being DEC3840) and apply your settings?

@Bopuppio45 The telco SFP module is not compatible with the DEC Router SFP+ specs. I am not the tech expert but there is a lot of literature on this. Hence the need for a bridge. What works: I took the XGS-Bridge Nokia XS-010X-Q and followed the steps from @Bluto and within a few minutes you’re good to go. I connected the Nokia bridge (10GB RJ45) with a Ethernet cat 7 cable with a 10GB ETH RJ45 SFP in the DEC840 SFP+ slot. If you got the Swisscom TV box, pls follow the steps for IPTV in the tread as well.

@Bopuppio45, @Chris99 was faster than me to answer and he’s right. At this time you need a bridge.

Thank you both, I wasn’t aware of lack of compatibility with the Zyxel SFP module. As odd as it may sound, it seems that it gets recognized on my DEC3840 although I haven’t had time to play with it and configure it as per your guidance.

@Bluto btw: did you get native IPV6 with the Nokia XGS-PON bridge, OPNsense to work?

Hello everyone,

If anyone is still looking for the Nokia ONT XS-010X-Q fiber converter, I still have one. It was in my company for almost 2 months and is currently no longer needed. 2 year warranty, purchased from init7.

@Tiofrischie85 wrote you a PM.

Please excuse me, unfortunately I only noticed it now.