Hi all, I posted in here a week or so ago re my TV box but - three factory resets later - the issue keeps occurring. When I put my TV box in standby mode, for example overnight, it keeps activating itself and then crashing. When I come to use it all I get is a blank screen, or it works for a couple of minutes and then crashes with a blank screen. For example I put the box in standby last night around 22:30 (checking for the red light on the box!) but when I looked at 07:30 this morning it was on (white light on the box and blank screen when I turned the TV itself on). When I run the reset it does work again, also sometimes I just need to turn the box off and wait for a few minutes before turning back on again. There's no issues with the TV box after restarting (get the TV guide, watch channels, all functioning), until it crashes again. There's no issue with the TV itself, network connection or network itself - all other things are running fine. I'm not sure if I can get Swisscom to send me a replacement box? It's very frustrating to keep having to run restarts. I'm also not sure what could be pushing the TV box out of standby mode? There's just me in the house, only one paired remote. Any advice most welcome; thank you all in advance.
I have a Swisscom 2.0 box. I always put it in standby when not being used. The last week it has been turning itself on from standby - not promoted by anything, it activates and then freezes. The only thing I can do is turn it off for 30 seconds (fully fun off, not just standby) and then turn on again and wait for the operating system to reboot. I checked the system online and Swisscom says there's no issues with anything. On the few times it hasn't activated itself and I turn the box on as usual (from standby) it's crashing after 10 minutes and I just get a blank screen. Any advice how to address this? Everything is connected as it should be and there's no problem with my internet otherwise. Thanks!